Snap XT device guide

Access Control Set Up

Posted on

Access Control Set Up Relay Trigger: To open the door locks directly without the controlling system. Circuit Diagram of Relay Trigger: Common OFF Configuration Common ON Configuration Physical Hardware Configuration: In Relay, power options are not definite. DC12 voltage or higher voltages can be used. Power Source Cable: If there is no power source, you Read More

Snap XT device guide

Register and Connect Device to the CERTIFY.me Platform

Posted on

Device Registration Device registration is done through https://portal.certify.me/. For details on adding the device to portal, click here After the device is being added through the portal, go to Settings page in CERTIFY Snap application. At bottom – left of the settings page the following details should be seen:Serial NoDevice NameDevice SettingsDevice Mode – OnlineDevice Read More

Snap XT device guide

Temperature Calibration

Posted on

Go to Temperature Settings → Click on TEMPERATURE CALIBRATION. Temperature Calibration: Click on Temperature Calibration. Distance: Set the distance value. Default value is 50. CALIBRATION – Click on CALIBRATION to scan the temperature. Once the temperature scan is done, it will show the scan results and the status should be ‘Calibration success!’. Tip: First, keep Read More