Access Control

Check the ‘Automatic Doors’ checkbox to enable the doors open automatically after the temperature scan.

Enable Relay:

Allows to take temperature facial scan for the existing Access card holders which is synced in Member management. Access will be denied for non existing card holders.

Allow Anonymous:

Allows to take temperature facial scan for non existing Access card holders. Member name will be stored as Anonymous in Reports.

Block access:

Normal mode: Based on relay for every scan, it block access for high temperature scan if checkbox is enabled.

Reverse Mode: Based on relay for High Temperature scan.

Door Control Timing:
This is the relay time where the signal will reach the door control after the temperature scan.
By default it is 5 seconds.

Enable Access logging and Attendance Reporting
Check the Enable Access Control to give access to the members by opening the doors when the members scan their access card on the device.

Message Format(Access Controller Card Format:)
Select the card format 26bit or 34bit or 48 bit for access card

Click on SAVE to save the above settings.

Leave a Reply

%d bloggers like this: