Pole and Desk Stand Setup

By Shiva ReddyDevice and Stand, Snap XT device User guide, User Guides

The following guide covers the installation of the Light Up Pole and Desk Stand.

Light Up Pole Stand

  1. Dimensions:

    1. 3’10” from floor to top of stand

    2. 4’5″ from floor to black cap

    3. 5’1″ from floor to top of SnapXT

  2. Setup:

    1. Review the device ports before installation

    2. Feed the wires through the mount from largest to smallest plug (RJ45, Relay, Power Supply, DC 12V & RS485)

    3. Press black cap back on. Then, feed cords through back triangle cover.

    4. Feed wires through circular bottom of mount, from largest to smallest.

    5. Attach mount to device with 4 small silver screws.

    6. Take off screws from the bottom of the stand.

    7. Slide large black triangular base to silver stand.

    8. Attach 3 silver screws and tighten.

    9. Take the black plug from the stand and connect to the Power Supply plug (white cord on the device).

    10. Take the yellow capped power supply cord from the stand and connect to power supply adapter.

    11. Place all device and stands cords inside the stand.

    12. Secure device with 4 small black screws.

    13. Plug main power source into outlet and connect the power supply cable to the base of the stand.

Light Up Desk Stand

  1. Dimensions:

    1. 2.5 inches from desk base of stand

    2. 9 inches from desk to black cap

    3. 1’6″ from desk to top of SnapXT

  2. Setup:

    1. Review the device ports before installation.

    2. Pop off the black cap and unscrew the bottom of the mount from the device stand.

    3. Feed the wires through the mount from largest to smallest plug (RJ45, Relay, Power Supply, DC 12V & RS485)

    4. Unscrew 6 black screws and remove the bottom of the stand.

    5. Press black cap back on. Then attach mount to device with 4 small silver screws.

    6. Feed cords through black triangular base.

    7. Feed wires through circular bottom of mount, from largest to smallest wire.

    8. Before the next step, align the tablet face with the light on the base.

    9. Tighten silver base with tablet to secure black triangular base.

    10. Take the yellow capped power supply cord from the stand and connect to the black power supply connector.

    11. Take the black power supply cord from the stand and connect to the power supply adapter (white cord on the device).

    12. Place all stand and device cords inside the stand. Then replace the bottom and screw in place.

    13. Plug main power source into outlet and connect the power supply cable to the base of the stand.