Check the ‘Automatic Doors’ checkbox to enable the doors open automatically after the temperature scan.
Select Yes to block the door acces to high temperature scan.
Select No to allow the door access to high temperature scan.
Door Control Timing:
This is the relay time where the signal will reach the door control after the temperature scan.
By default it is 5 seconds.
Enable Access Control
Check the Enable Access Control to give access to the members by opening the doors when the members scan their access card on the device.
Access Controller Card Format:
Select the card format 26bit or 34bit for access card
Click on SAVE to save the above settings.
You must log in to post a comment.