Certify.me User ManualUser Guides

Scan View

Scan View:

Display temperature:
To display temperature select ‘Yes’.
Select ‘No’ if not required.

Capture image of user:
To capture images select ‘Yes’.
Select ‘No’ if it is not required.

Capture image:
To capture only high temperatures select yes, otherwise select ‘No’

Enable Mask Detection:
To show the status bar whether the mask is detected or not.

 

Enable Temperature scan under Scan view settings

Allows to do perform facial temperature scanning with capturing images

Disable Temperature scan under Scan view settings.

For RFID à when tapping RFID Cards on the device. The behaviour is just “:Thank you “confirmation message appears and goes back to home page.

For QRCode à when scanning QR Code on the device. The behaviour is just “:Thank you “confirmation message appears and goes back to home page.

For Facial à when member stands for facial scan near the device,The behaviour is just Facial Camera is open and just “:Thank you “confirmation message appears and goes back to home page.

For Wave à when member perform wave interaction,The behaviour is the member answer the questions and just “:Thank you “confirmation message appears and goes back to home page.

Temperature Compensation: Allow the device to give accurate body temperature of the member by detecting the room temperature with this compensation value.

Display Result bar : It is something like a custom text given for high and normal temperature replacing the default text.


By default,
the screen delay time is 5 seconds, high temperature threshold we can set 99 or below.

Read and display temperature in: Temperature can be displayed either in Fahrenheit or Celsius by using it.

By default, low temperature threshold is 93.2.